Dle 20 Instrukcja Użytkownika

DLE-20Operator’s ManualSpecifications20cc [1.2 cu. in.]2.5 HP / 9,000 rpm1,700 rpmElectronic Ignition 14u10, 15u8, 16u6, 16u8, 17u6CM6(Gap) 0.0

109. Install the choke servo (optional) at the same distance as the throttle servo from the engine. Be sure to use a non-metallic linkage and a Faslin

11Install the Propeller1. It is recommended that you test-run, tune, and/or break-in the engine before fl ying. To make this easier we recommend that

12Adjustment of the EngineEach DLE Engine has been factory preset. However, differences in elevation will infl uence the performance of the carburetor.

13turn the needle to the fully stop/closed position and then open the needle 1.5 turns). It is recommended that the High-speed needle be adjusted by t

14Problem: If Your engine does not reach full rpm. or Carbon build-ups appear consistently on your spark plug.Solution:The high-speed needle valve

15B. Electric Starter StartingA 24V electric starter is recommended to start the DLE-20 1. Make sure you use a good quality, lightweight aluminum spi

16Engine TroubleshootingIf your engine fails to start after the preceding starting procedures please check the following.Symptom Diagnosis FixEnginedo

17Optional Digital Tachometer (not included)An optional Digital Tachometer is available that can be directly connected to the ignition and display the

18Engine MaintenancePlease clean the fuel fi lter in the DLE Carburetor periodically. Failure to do so may result in miss-calibration of the needle adj

19Warranty InformationThe DLE-20 has a two year limited warranty through Hobby Services beginning at the date of purchase. Please retain your receipt

2Parts List (1) DLE-20cc Gas Engine w/DLE MP 148 100424(1) DLE Spark Plug (NGK CM6 size) with additional spring(1) Muffl er with gasket (2) 4 x 14 mm S

2015818113021172214926321312329101201975427282625162423

21Replacement PartsStockNo.KeyNo. Description DLEG2001 1 Cylinder DLEG2002 2 Crankshaft DLEG2003 3 Crankcase 22 Back Plate DLEG2004 4 Piston

223.56 in.[90 mm]2.25 in.[57 mm]0.98 in.[25 mm]2.20 in.[56 mm]2.37 in.[60 mm]

23

DLE-20 Mounting Patternwith DUBG1307 Engine Mount 2.75 in.[70 mm]2.75 in. [70 mm]

3● For your safety and the safety of others, please do not stand in front or in line with the propeller when the engine is running. Keep onlookers a

4Install all electronic radio devices as far away from the engine as possible.● The throttle and choke pushrods should be non-metallic.● If the en

5Installation InstructionsPrepare the engine for installationBefore beginning installation it’s a good idea to plan location of the various components

6 3. Connect the kill switch lead to the red connector from the ignition control module using the lead from the kill switch or with the included three

77. Secure all connections with heat shrink tubing (not supplied).8. Install the silicone ignition wire cover over the ignition wire.9. Install the

8on the bolts before securing the nuts onto the bolts on the rear of the fi rewall. Be sure to use Threadlocker on the screws holding the engine mount

9 7. Install the throttle servo as far as possible from the engine. Make sure that you get the carburetor’s full range of rotation with your servo tr