Dle 20RA Instrukcja Użytkownika

DLE-20RAOperator’s Manual20 cc [1.22 cu. in.]2.5 HP / 9,000 rpm1,700 rpmElectronic Ignition 14u10, 15u8, 16u6, 17u6CM6(Gap) 0.018in.– 0.020 in.

1014. Please ensure the sensor wire is supported as close to the sensor pick-up as possible. Flight loads may cause stress and damage to the wire wher

11Starting ProceduresThere are two recommended ways to start the DLE-20RA:A. Manual StartingNote: When hand starting the DLE-20RA, use a thick glove o

12B. Electric Starter Starting 1. A 24 volt electric starter is recommended to start the DLE-20RA. Make sure you use a high quality, lightweight alum

13Engine TroubleshootingIf your engine fails to start after the preceding starting procedures please check the following.Symptom Diagnosis FixEnginedo

14Adjustment of the EngineEach DLE Engine has been factory preset. However, higher elevations will infl uence the performance of the carburetor. To obt

15turn the needle to the fully stop/closed position and then open the needle 1.5 –2 turns). It is recommended that the High-speed Needle be adjusted b

16Problem: If Your engine does not reach full rpm. or Carbon build-ups appear consistently on your spark plug.Solution:The high-speed needle valve

17Engine MaintenancePlease clean the fuel fi lter in the carburetor periodically. Failure to do so may result in mis-calibration of the needle adjustme

18Warranty InformationThe DLE-20RA has a two year limited warranty through Hobby Services beginning at date of purchase. Please retain your receipt as

1993mm57mm25mm60mm4.20mm56mm

2Parts List (1) DLE-20RA Gas Engine with DLE Carburetor(1) CM6 Spark Plug with Spare Ignition Wire Spring(1) Muffl er w/Gasket(2) 4x 20mm SHCS with 4mm

20525952024262728291716181312111068743131302319222123415143233

21Replacement PartsKeyNo.Optional Parts (not shown)StockNo.Mfg StockNo. Description 1 DLEG2301 20-V1 Propeller Washer 2 DLEG2302 20-V2 Propelle

22Notes

23DLE-20RA Mounting Patternwith DUBG1307 Engine Mount 2.75 in.[70 mm]2.75 in. [70 mm]

3● For your safety and the safety of others, please do not stand in front or in line with the propeller when the engine is running. Keep onlookers a

4● Always fi lter your fuel by using an appropriate fi lter before putting it into the airplane’s fuel tank.● Gasoline is extremely fl ammable. Keep

5Installation InstructionsPrepare the engine for installation1. Check to see that all screws and bolts are tight. Check carefully for any cracks, brok

6Ignition Wire(To Spark Plug)Ignition Control Switch Wire (To On/Off Switch)Pick-UpSensor Wire(To SensorOn Engine)Tachometer Lead/RPM Signal OutputELE

77. Secure all connections with heat shrink tubing (not supplied).8. Install the silicone ignition wire cover over the ignition wire to the spark plu

8exits the engine compartment or the fuselage; most vent lines exit at the bottom of the fi rewall).You can fi ll the tank by using the carburetor line

9Components for the non-metallic linkage can be purchased at your local hobby shop.7. Once the throttle servo is installed it’s a good idea to deact